Project Description:
Design a new schematics and PCB layout for a GoGo Real Board.
This board was designed by me, but I not good with electronics. This board aims to control 4 motors, read 8 sensors, receive commands from USB. The board is powered with 8V/2A batteries. The motors can be set to receive 5v from regulator (the same that powers the pic) or 8v from batteries.
This board must be done with Cadsoft Eagle, Using a PIC18F4550 and smd layout.
The board must have:
- In-Circuit. Serial Programming ( ICSP )
- USB 2.0 connection
- control 4 DC motors using 2 L293B, each chip L293B will have a switch to choose 5v regulator or DC output from batteries
- 8 A/D channels for read sensors
- Use terminal block , 3way , 5.08mm pitch Spacing, like the CTB9358/3 at http://uk.farnell.com/
- One reset button
- One simple button
- One led or RGB led.
- One piezo beep
- I2C connection.
There are many improvements that can be done, any suggestion for improvement is welcome.
CAD/CAM, Electrical Engineering, Electronics, Microcontroller, PCB Layout Additional Files: Real.brd Real.sch
You will not be able to bid on this project if you are not qualified in one of the job categories. To see your qualifications click here.
