Circuit & PBC Design for LED & Laser Diode

Avg Bid (USD)
Project Budget (USD)
$30 - $250

Project Description:
- Using Battery CR2 3V.
- 2 SPST Switches On/Off. 1 For Led 1 For Laser Diode
- 1 LED = (Cree XP-G)
- 1 Laser Diode. 10-15ma Draw (2.8-3.v)
-PCB max size = 17mm x 18mm
-Led, Laser Diode, battery and Switches to connect to PCB. Hopefully with micro connectors.

I am looking for 2 Modes for LED. 1 Mode for Laser Diode

On = 600ma, Push On 3 Sec(or another way) 300ma, also 300ma when battery V < 2.8V or whatever voltage you think is the one. I am also looking for a good efficiency driver and low parts cost. The stated ma, is ideal, but if similar a doable ma's are better for any other reasons I am not fixed on those.

A lot of similar drivers use 1 x AMC7135 chipset , for 350ma and 2 x for 700ma, as it offers some battery cut off protection and seems to be very efficient with li-ion batteries.
I have done some research, and for this battery 1 x AMC7135 seems good, but 2 would drive 700ma which is not realistic for a 3v battery.

For controlling modes the ATTiny13A seems to be the one mostly used.

I have seen other multi-output Pmic's, but dont want to influence your selection now.

I am looking for the PCB design in a ODB or AutoCAD dxf as well as a list of parts and an explanation of it. Before design, I will tell you where I need the connectors for switches, battery, led & diode.

Skills required:
Circuit Design, Electrical Engineering, Electronics, Microcontroller, PCB Layout
About the employer:
Public Clarification Board
Bids are hidden by the project creator. Log in as the employer to view bids or to bid on this project.
You will not be able to bid on this project if you are not qualified in one of the job categories. To see your qualifications click here.

$ 894
in 7 days
$ 255
in 3 days
$ 200
in 10 days
$ 147
in 3 days
$ 222
in 3 days
$ 255
in 7 days
$ 244
in 3 days
$ 200
in 3 days
Hire Guxx
$ 155
in 5 days
$ 277
in 3 days