Making a Charging circuit PCB for LiPo 8S/240V - Repost

IN PROGRESS
Bids
10
Avg Bid (USD)
$380
Project Budget (USD)
$10 - $30

Project Description:
Making a Charging circuit PCB for LiPo 8S/240V

We want to build a small, simple but efficient integrated charging circuit for LiPo batteries, 3S up to 8S in configuration. It should be able to get power directly from a 230V outlet. It should be able to charge the batteries and balance the cells. It should also be able to shut down the power to the ESC while charging to avoid short circuit.

Requirements:

Charge and Balance LiPo batteries up to 8S in cell configuration.
230V 50hz Input
Should be able to be integrated in existing project
2 or 4 Layer PCB
PCB Design using EAGLE
Ability to Switch between charging and “Drive” mode
Short circuit protection
Over voltage protection

The design must use chips from either Maxim Integrated (MAX8804) or from Texas Instruments (BQ2954)

LiPo battery has Positiv/Negative and balancing leads.
----------------

Simple overview/wiring diagram:
https://www.dropbox.com/s/5nb9olx8w76nn71/ChargingLiPoEV.png

Additional Project Description:
08/28/2013 at 18:21 IST
Preferable is to use of 5x5 cm 2-layer PCB or 10x10cm 2-layer PCB

Skills required:
PCB Layout
Hire ChinaSweden
Project posted by:
ChinaSweden United States
Verified
Public Clarification Board
Bids are hidden by the project creator. Log in as the employer to view bids or to bid on this project.
You will not be able to bid on this project if you are not qualified in one of the job categories. To see your qualifications click here.


$ 333
in 3 days
Hire NpMOS1
$ 85
in 12 days
Hire mainenot
$ 444
in 7 days
$ 277
in 20 days
$ 500
in 7 days
Hire ahmadFayek
$ 555
in 10 days
$ 750
in 3 days
Hire MayankPatel83
$ 555
in 20 days
$ 100
in 7 days
Hire mdnor76my
$ 200
in 7 days