You have chosen to sponsor your bid up to a maximum amount of .
We have a custom designed embedded board which is based on P89c669 from Philips/NXP. As nxp669 is ended i need to transfer my application to another micro controller.
1. We do not want to changed the embedded board just want to replace main micro-controller (p89c669Fa). As there will be pin compatibility issues we will need small daughter board to fit "44 Pin PLCC IC Socket" place. (Can be soldered either). So designer will design this board too.
2. All Board is working with 5v DC.So new micro controller should able to work with same levels.
3. New Miro controller should have :
a) least 2 UARTSs (One is used for RS232 and the other one is used for Current Loop Communication on board)
b) i2c port as main peripherals and the board is using i2c to communicate each other.
4. Program sizes data of software from Keil4 as below : data=199.3 xdata=1724 const=0 code=64552. So the new micro controller should able to run this micro controller too.
5. Program is written in Keil C 8051 version.New micro controllers software better to be written in Keil C environment.
NXP recommend to use Cortex M0/M0+ basedÂ LPC1100/LPC800 family, for more info see:http://www.nxp.com/products/microcontroller/cortex_m0_m0/
Another friend is advise to use SLLC8051 series from Silabs