PIC or MCU Based Water Pump Counter Display

IN PROGRESS
Bids
14
Avg Bid (GBP)
£147
Project Budget (GBP)
£20 - £250

Project Description:
I would like to create a PIC or Atmel MCU based pump. It will work much like a petrol pump works at the garage. When the switched input is enabled, the Display must run a set clear routine, then, switch the relay, this will in turn start the motor. The Pulsed input will pulse at a known rate, to record the amount of water pumped though, the display will update in real time this figure. Just like a petrol pump would. The Pulsed output will pulse at a set amount depending on a jumper setting. 3 or 4 options. When the switched input is then turned off, the relay must be switched off, and the total amount remain on the display. Until the next time the switch input is triggered, then the sequence is started all over again. It must have an EEPROM, or some kind of memory to record the grand total of water pumped, when a 2nd input button is pressed, this would then be displayed on the Display. I will need circuit design.

Skills required:
Electrical Engineering, Electronics, Embedded Software, Microcontroller, PCB Layout
Additional Files: pump.pdf
About the employer:
Verified
Public Clarification Board
Bids are hidden by the project creator. Log in as the employer to view bids or to bid on this project.
You will not be able to bid on this project if you are not qualified in one of the job categories. To see your qualifications click here.


£ 220
in 5 days
£ 100
in 7 days
£ 250
in 5 days
£ 100
in 1 days
£ 100
in 4 days
£ 150
in 3 days
£ 120
in 5 days
£ 100
in 7 days
Hire sergeydm
£ 250
in 15 days
Hire HSjith
£ 100
in 3 days