Drawings on how to install a self moulded mouth guard

Avg Bid (USD)
Project Budget (USD)
$30 - $250

Project Description:
I need 14 drawings/illustatrations that will show a person installing a mouth guard (device) that stops people from snoring. The device works by holding the bottom jaw forward that stops people from snoring.
Drawing 1
Inserting the spatula in the mouthpiece
Drawing 2
Putting the mouth piece in a bowl of boiled water (whilst holding the device by the spatula) for 17 seconds
Drawing 3
Shaking off any residual hot water from the device
Drawing 4
Inserting the device in your mouth
Drawing 5
Pulling your jaw forward by pulling the spatula forward that pulls the lower jaw forward
Drawing 6
Biting slightly on the device
Drawing 7
Using your index fingers to mould the front of the device against the outside of your teeth
Drawing 8
Using your tongue to tightly mould the inside of the device against the inside of your teeth
Drawing 9
Removing the device from your mouth and putting it in a bowl of cold water
Drawing 10
A cross section of the skull showing the lower mandible without the device
Drawing 11
A cross section of the skull showing the lower mandible held forward with the device in place
Drawings 12-14 kept spare

Skills required:
About the employer:
Public Clarification Board
Bids are hidden by the project creator. Log in as the employer to view bids or to bid on this project.
You will not be able to bid on this project if you are not qualified in one of the job categories. To see your qualifications click here.

$ 240
in 3 days
$ 150
in 5 days
$ 250
in 14 days
$ 200
in 10 days
$ 250
in 45 days
Hire shoomaila
$ 220
in 5 days
$ 120
in 5 days
$ 100
in 7 days