Solidworks Design for Magic Wand Housing for PCB

Avg Bid (USD)
Project Budget (USD)
$30 - $250

Project Description:
Looking for a SolidWorks design for a magic wand housing for a PCB with the following characteristics:

-Larger diameter at the base, 14 inches long, tapering to a point.
-Must accommodate a 6 inch by 1 inch wide printed circuit board inside with about .25" clearance on top and bottom
-PCB should mount in the wand via screws or other system
-Must accommodate 0.23"x1.16"x2.0" battery inside (like:
-Must have room to connect the battery to circuit board via cable
-Must accommodate a USB Mini-B jack. USB Jack should be on heel of wand.
-About halfway up the wand, there should be a set of 5mm LED lights, one every 90 degrees around the circumference
-There should be a channel to wire the LEDs to the PCB
-At the tip of the wand there should be space for an LED
-There should be a channel to wire the LED to the PCB
-About 3/4 of the way from the base to the tip, there should be room for a 5mm LED on the top side of the wand
-There should be a channel to wire the LED to the PCB
-On top of the wand, in the handle portion, there should be a button that looks like a gemstone.
-There must be internal space to wire the button to the PCB
-Wand should split into parts for easy assembly of internal components.

Design inspiration for how product might look:

Skills required:
3D Rendering, Mechanical Engineering, Solidworks
About the employer:
Public Clarification Board
Bids are hidden by the project creator. Log in as the employer to view bids or to bid on this project.
You will not be able to bid on this project if you are not qualified in one of the job categories. To see your qualifications click here.

$ 120
in 7 days
Hire Veritas66
$ 200
in 8 days
$ 150
in 6 days
$ 180
in 3 days
$ 100
in 2 days
$ 120
in 5 days
$ 40
in 8 days
Hire crishmarudima
$ 100
in 3 days
Hire arbaaz007
$ 200
in 5 days
$ 125
in 2 days