Edgemarc 4550 Router / Firewall Configuration +SIP

Avg Bid (USD)
Project Budget (USD)
$30 - $250

Project Description:
I need assistance with setting to configure an EdgeMarc 4550-15 call router for PhoneBooth's VOIP service. I have purchased an EdgeMarc 4550 Router to replace TP-Link. The router is connected from a Ubee DDW3611 modem [in bridge mode] out to a Cisco AP and two Cisco switches, one voice with 9 SIP phones and one data.
PhoneBooth's recommendations are:
Please have Edgemarc support with the below settings on the router.

-# SIP Signaling is on ports 5060 to 5090 UDP
-# RTP/Media is on ports 1024 to 19999 UDP
-Make sure consistent Nat is enabled and sip transformation is disabled.
-SPI or ALG needs to be disabled also
-Customer will need to open up the below range of ports on their firewall, or define a rule to allow traffic from our proxy -
-Have QoS set up on the router for the VOIP connection.

I basically need a brief description of those settings in EdgeMarc's GUI.
If I didn't give you enough information please let me know what additional information you need.

Skills required:
System Admin, Technical Support, VoIP
About the employer:
Public Clarification Board
Bids are hidden by the project creator. Log in as the employer to view bids or to bid on this project.
You will not be able to bid on this project if you are not qualified in one of the job categories. To see your qualifications click here.

$ 210
in 3 days
$ 157
in 1 days
$ 200
in 1 days
$ 77
in 3 days
Hire pandianmalachamy
$ 211
in 3 days
Hire hrjamshidi
$ 244
in 3 days
$ 222
in 1 days