You have chosen to sponsor your bid up to a maximum amount of .
Using Visual Basic (I have visual studio 2012) I Want to access my S3 drive on AWS.
I need to do put, get, delete, and list contents of bucket from command line. I do not care if parameters are retrieved from a text file or on command line (I can handle either method).
My bucket will be something like "steve" (I supply both keys), directories under steve will be data\00001, data\000002, etc. and that is where data will reside. I plan to move date from data\00001 to data\00001\archive when I am done with data, I do not have any issues doing a put and delete to do move.
So flow is I do a list of steve\00001.
Get data to local drive
I do my thing with data
I than need to move (delete and put OK issued from my side via your program) of data from steve\data\00001 to steve\data\00001\archive.
I hope I did a good job explaining but to further explain. End result would be..
new-program -key1= -key2= list steve\data\00001 results.txt (this result creates a local file name results.txt)
new-program -key1= -key2= put localfile steve\data\00001\archive
new-program -key1= -key2= get steve\data\00001\filename
new-program -key1= -key2= delete steve\data\00001\filename
Of course I send full directories from command line (or config file), no need to hard code directories.