Arduino to Arduino project

CLOSED
Bids
12
Avg Bid (USD)
$172
Project Budget (USD)
$30 - $250

Project Description:
I have a small project where I need to pass information between two arduino Uno's V3 to move standard RC servos or sense if water has been detected.

The two Uno's will be 50 meters apart........... So not sure the best way to handle the serial communication. Rx / TX to TX / RX or a pair of MAX232 chips?

Need Sketch for Uno #1 and Uno #2.

10K ohm rheostat input (1) on Arduino #1 to control servo output on one of the PWM outputs of Arduino Uno #2 - camera_tilt
10K ohm rheostat input (2) on Arduino #1 to control servo output on one of the PWM outputs of Arduino Uno #2 - camera_pan
10K ohm rheostat input (3) on Arduino #1 to control servo output on one of the PWM outputs of Arduino Uno #2 - LED_1
10K ohm rheostat input (4) on Arduino #1 to control servo output on one of the PWM outputs of Arduino Uno #2 - LED_2
10K ohm rheostat input (5) on Arduino #1 to control servo output on one of the PWM outputs of Arduino Uno #2 - claw _motor
10K ohm rheostat input (6) on Arduino #1 to control servo output on one of the PWM outputs of Arduino Uno #2 – laterial_motor
If Flood_Sensor_1 = HIGH on Arduino #2 then illuminate LED_1 on Arduino #1
If Flood_Sensor_2 = HIGH on Arduino #2 then illuminate LED_2 on Arduino #1
If switch_1 (digital input) is set to HIGH on Arduino #1 then blink LED on Arduino # 2 ( 80ms ON, 80 ms OFF, 80ms ON, 1000ms OFF) - beacon
If switch_2 (digital input) is set to HIGH on Arduino #1 then turn an OUTPUT on Arduino # 2 to HIGH – camera_ focus_in
If switch_3 (digital input) is set to HIGH on Arduino #1 then turn an OUTPUT on Arduino # 2 to HIGH – camera_ focus_out
If switch_4 (digital input) is set to HIGH on Arduino #1 then turn an OUTPUT on Arduino # 2 to HIGH – camera _power
If switch_5 (digital input) is set to HIGH on Arduino #1 then turn an OUTPUT on Arduino # 2 to HIGH – camera _zoom _in
If switch_6 (digital input) is set to HIGH on Arduino #1 then turn an OUTPUT on Arduino # 2 to HIGH – camera _zoom _out
If switch_7 (digital input) is set to HIGH on Arduino #1 then turn an OUTPUT on Arduino # 2 to HIGH – spare

Skills required:
Arduino
Additional Files: water+sensor.jpg water+sensor_1.jpg
About the employer:
Verified
Public Clarification Board
Bids are hidden by the project creator. Log in as the employer to view bids or to bid on this project.
You will not be able to bid on this project if you are not qualified in one of the job categories. To see your qualifications click here.


Hire tus707
$ 160
in 7 days
$ 150
in 7 days
Hire rajvigneshtn
$ 150
in 5 days
$ 250
in 15 days
$ 240
in 5 days
$ 120
in 5 days
$ 200
in 5 days
Hire cclaus
$ 150
in 5 days
Hire bsw
$ 150
in 1 days
$ 200
in 15 days