You have chosen to sponsor your bid up to a maximum amount of .
I am looking for an experienced Arduino programmer to write a sketch for me.
I will be buying a 7" HDMI monitor with a 4 wire resistive touch screen. I would like the touchscreen inputs to pass through an Arduino atmega328 and then using a bluetooth shield turn them into a HID bluetooth mouse to be used on HID Bluetooth compatible devices.
My use for this is to output my iPhone screen onto the 7" HDMI touchscreen monitor via a standard iPhone video cable then via bluetooth between the Arduino (connected to the touchscreen) and the iPhone.
control the iPhone completely via the external monitor.
I have tried to provide any current information from the internet that i think may be of use.
The iPhone App
This is the app that will be installed on the iPhone which enables any bluetooth mouse to be able to connect to an iPhone and control it.
This is an Arduino sketch that i have found that lets you plug a standard usb mouse into the Arduino computer and translate the x y and mouse clicks to be sent via bluetooth. All i believe that would need to be done is instead of using usb, have the inputs from the 4 wire resistive touchscreen.
Arduino sketch for touch screen.
This is another sketch I have found that uses a basic 4 wire resistive touch screen to control the Arduino. Again this may be of use to make it easier to set up.
I have also provided the parts I believe I will need to make this work. Please be open to giving any advice on better parts for this project. My aim is to keep it as low cost as possible without compromising on use. If you find any less expensive parts that do the same job please let me know
Touchscreen HDMI monitor
Given all the information above this should not be a big project and for an experieced Arduino programmer should only take a few hours. Any advice or questions please pm me.