Throttle body design
My first update on the project: 1. I have designed the low profile throttle body with a 60.04mm inlet diameter. 2. I have solved the design without axis of the blade, I attach an exploded view to see if they are able to manufacture all the components. Pending: I am currently designing the control and regulation system of the throttle body, I would like you to provide me with measurements A, B and C of the last image to take them into account on the design i hope your feedback
Public Clarification Board
-
luisosechas91
- 3 months ago
I would like to receive some incentive to continue the design as it is a job that takes time and dedication, it would be great if I could guarantee the contest
- 3 months ago
-
Contest Holder - 3 months ago
It is a bit early to close the contest to be fair, but to honest we think you might be the one we are looking for. Again well done!
- 3 months ago
-
Contest Holder - 3 months ago
For inspiration you can have a look at this page, link below. Its not the same engine but very nice solutions. We would prefer to have drive by wire electrical motor in the rear so we do not block incoming air to the intake. This example has the mounting in the middle. https://rennlist.com/forums/928-forum/910228-itb.html
- 3 months ago
-
Contest Holder - 3 months ago
Luis, that is a very good start! Well done. Some feedback/questions: 1. There is no need for screw/mounting holes of the body. It can be CNC and be a part of the whole manifold design. 2. Bearing would you recommend ball bearing or traditional?
- 3 months ago
