Lav nogle 3D Modeller
- Status: Closed
- Prize: $50
- Entries Received: 4
- Winner: darkcaper3d
As a D&D nerd (or should i say all spellcasters in D&D) are challenged with utilizing spellslots or any other markers that is used on a "day to day" basis inside of D&D
The project is a flat board with room for spellslots with an additional board that handles all other slots imaginable. The whole thing comes together with magnets.
It needs to come with a removable stand so it can be upright to save space on the table.
The additional board needs to be just as tall as the other board with room for as many nameplates and following pins. On the additional board there also needs to be room for 7 pins per nameplate and an extra nameplate (not visualized) at the top.
The nameplates needs to fit the nameplate holes but there need to be enough material on either side so you can remove it with your fingernails.
The magnet holes needs to be standard magnet sizes (3x3mm) as shown here:
The final product must be so its easy to 3D print.