The Skull and Baby Rattles
The Jaw was removed as the illustration. The model follows the gestures of the illustration. The general form correspond to the measurements. The model is one entire piece. The unique extrude was the title. Wasn 't necessary micro details, 'cause the 3d printers cannot do that precision. The model was modelled in Solidworks, Zbrush and Blender. Curiosities: The diameter is three times largen than the distance between the teeth and the back. I'm new to this website and this is my first entry. Thanks by the attention, I hope you like. Author: Andrew Kennedy
Public Clarification Board
-
Contest Holder - 7 years ago
It feels like the teeth are protruding too much, giving the skull something of an "ape/gorilla" look.
- 7 years ago
-
andrewkfa
- 7 years ago
Ok sir, I'll change it now.
- 7 years ago
-
Contest Holder - 7 years ago
Nice. Can you send me a shot of this from the edge? I can't tell how far the skull protrudes from the surface of the disk.
- 7 years ago
