Ansys Software Expert- Mechanical Engineer- Solid Works
I am a Btech 4th year student. I am doing a project on heat exchanger. The project requires the simulation analysis of heat exchanger to determine the temperature variations in the heat exchanger. The project constitutes designing, meshing, and analysis
I need some help with internet marketing.
I am looking for a small job: 1-design via (workbench ansys 14.0) 2-explanation step by step how you did it in a word document. 3-only one solar panel with 60 degree and 5m high from the ground. so the Influential factors should have. wind and radiation, sands accumulation, air, soiling accumulation I want just do analyses to see which is the
I need an ansys fluent study to simulate the thermoregulation of human body. Gagge's two node model is need to be applied for it. Formulas and theorical definition of this model is available on google. A basic manikin can be used for it. Aim of this study is to obtain dynamic the skin temperature which changes with enviromental conditions.
I want to analyze the motion of the damper as quarter car model using FEA. I want to see how the motion of the mass rigidly attached to the piston is damp...viscosity when the cylinder of the shock absorber is subjected to the excitation. Or the vice versa. I want to do the multiphysics analysis of this phenomenon. Comsol 5.3a or Ansys is ok for this.
I am looking for someone who is able to TEACH me on skype how to do stress analyze of adhesive joints of a Single Lap joints. Preferebly on ANSYS Workbench (because I have some experience) or ANSYS Apdl. The person need to be able to teach: The simulation setup. How to set the contact of aluminum/adhesive/aluminum. Cohesive zone. Run
I am looking to build a CFX simulation of a given CAD model. Solidworks flow simulation is used for determining the flow paths and then simulated with ansys fluent for combustion simulation. The problem is i don't know any parameters, i need your experience for that+chemistry knowledge about a gas fuel which is used. I need it need to be very
need to optimize the hole size of the air going in and out to control the the heat and move the heat sources around and thine and thike the main plate to produce a even results across the plate. ill need to optimize the height and hole size of the steam holes, the height prevent liquid water to drip out placing the exit higher then the surface of the water and controls the type of steam lair the e...
auto cad, solid works, creo, ansys, catia, 2D & 3D Drawings for all enginering equipments, constructions are done online at low cost, you just send me your project details, or photos, or hand made sample drawings, descriptions, we can design your job, and send you soon.
Need to do some simulations with roller bearings and lead screw , preferably on Ansys. The model is almost complete, but needs your adjustments