Microcontroller pic jobs

Filter

My recent searches
Filter by:
Budget
to
to
to
Skills
Languages
    Job State
    5,481 microcontroller pic jobs found, pricing in USD

    This is about creating a demo which connects ESP32 microcontroller to Bluetooth headset, where it gets just a few seconds of audio after pressing a button on headset and plays it back to headset. Successful freelancer will get US$300 for his sourcecode (made in Arduino IDE !!!) after demonstration and awarded with further development. Proposals without

    $104 (Avg Bid)
    $104 Avg Bid
    7 bids
    Program a microcontroller 4 days left
    VERIFIED

    need you to program a micro controller as per my requirement

    $22 (Avg Bid)
    $22 Avg Bid
    15 bids

    PLS MESSAGE ME AS SOON AS POSSIBLE. URGENT!!

    $124 (Avg Bid)
    $124 Avg Bid
    7 bids

    ...hall effect sensor can be in either of their states (“ON” or “OFF”) for weeks, during which time they shouldn’t drain the batteries. They should only use energy when the microcontroller is checking their status. The DC motor will only run for a few times a week during a few seconds. It should run on about 9V. I need your help to design a complete

    $249 (Avg Bid)
    $249 Avg Bid
    28 bids

    ...protocols, technologies and tools to implement the solution in line with the IoT solution architecture Requirements: • Experience in Designing with 8/16/32 Microprocessor / Microcontroller . • Familiar in various communication Interfaces like RS232, RS485, USB, I2C , SPI, SATA, PCI etc. • Familiar in Schematics entry using Orcad 16.6, PADS 9.4.1. • Hands

    $626 (Avg Bid)
    $626 Avg Bid
    11 bids
    microcontroller alarm device 1 day left
    VERIFIED

    When a school bus arrives at the school after picking up the students the bus driver or bus attendant is supposed to check whether any students are left behind by going upto the back seat of the bus after every trip. But sometimes the drivers forgets or just dont want to walk upto the back seat. We want to avoid such a situation. We want to develop a controller that will trigger the horns on an...

    $262 (Avg Bid)
    $262 Avg Bid
    33 bids

    there will be a bulb which can be connected to wifi using a microcontroller/wifi module. and which can be turned on&off based on the data corresponding to that bulb in firebase. our bulb should be able to connect to any wifi using an app. p.s : we need app also just to connect our bulb to any wifi.

    $125 (Avg Bid)
    $125 Avg Bid
    8 bids

    This is about creating a demo which connects ESP32 microcontroller to Bluetooth headset with a microphone, gets 3-5 seconds of audio after pressing a button on headset and plays it back to headset. Successful freelancer will get US$300 for his sourcecode (made in Arduino IDE) after demonstration and awarded with further development. Check my reputation

    $236 (Avg Bid)
    $236 Avg Bid
    16 bids

    Need Following software module writing :- 1. RX62T board communication with programmer 2. Initialization all port pin. 3. make digital Input module 4. make digital Output module. 5. make Keypad Module 6. make UART module 7. make ADC module 8. make phase current sense module. 9. make display module 10. make PWM module.

    $126 (Avg Bid)
    $126 Avg Bid
    5 bids
    Project for Regul E. 14h left
    VERIFIED

    Hi Regul E., I noticed your profile and would like to offer you my project. I am designing a microcontroller system that needs to automatically turn on and off a light bulb when a sensor is traced through 2xPIR sensors. An LDR is also being used to determine when to activate the system based on lighting in the room. I need a PCB designed and some simple

    $12 / hr (Avg Bid)
    $12 / hr Avg Bid
    3 bids

    ...add features and make fixes discussed in the attached file. Required Skills: 1. Bluetooth BLE chip integrations that are easily compatible with ANY Smartphone 2. Microcontroller experience (especially ATmega32u4 ) 3. Charging Lithium ion Batteries with FAST Speed (VERY SAFELY Though) 4. To be precise, our board is powered by 2 batteries (each

    $711 (Avg Bid)
    $711 Avg Bid
    14 bids

    I am an event organiser and I distribute e-cigarettes to guests attending the events. A lot of my cigarettes have been stolen at such events and since these do not come cheap, I need some way to prevent stealing of the cigarettes. So, I need to install a small GSP tracker or any device(micro-controller) along with a buzzer in an e-cigarette. The buzzer will start buzzing once the e-cigarette goes ...

    $143 (Avg Bid)
    $143 Avg Bid
    8 bids

    I have sch file that i need a Gerber file, Schematic ,BOM and write a small program for pic16F and FPGA Microcontroller that controls the board, here is jpeg file for this. you must check my sch and tell me about issue that it has. then after it you can bid to my project and we can go ahead. you should be able to explain about following swapped

    $512 (Avg Bid)
    $512 Avg Bid
    17 bids

    I need help with creating a boot loader for atMega1281 microcontroller. I want the boot loader to check the SD card for a new version of code and load into flash and start running. I have already created the main application and I have also created a bootloader file to read the SD card etc. from a tutorial I found online. However, I am missing something

    $190 (Avg Bid)
    $190 Avg Bid
    10 bids

    To create PID program for Arduino *Analog Voltage In (Input Sensing) *Analog Voltage In (Out Put Sensing) *Set Point *Kp, Ki and Kd *Frequency In (For Multiply with PID out put PWM) *Out Put 1, PWM from PID *Out Put 2, PWM from PID x Frequency (So that it become AC Sign Wave) Attached block diagram.

    $126 (Avg Bid)
    $126 Avg Bid
    12 bids

    I need redesign of my board and firmware programming, it's a Gps tracker with 3g module and btle module with microcontroller

    $11 / hr (Avg Bid)
    $11 / hr Avg Bid
    1 bids

    ...sure which battery pack/jacks/fuse... are best suited, so I appreciated suggestions; - batteries must be rechargeable; - battery level must be read by microcontroller; - as a main microcontroller I would use an ESP8266 12 (Wizzy, NodeMcu); - both slaves and master must consider a MPU6050 (GY520) and a HX711 with pins exposed for easy and connections;

    $523 (Avg Bid)
    $523 Avg Bid
    30 bids

    Limit amount of parameters to be able to be changed in the app. The app will connect to a Redbear Duo microcontroller and send/receive data about the current parameters. Will keep motor run screen but the number of seconds of Acceleration/Deceleration will be reduced. List of parameters that will be used: 00 - Overvoltage Alarm, 01 - Undervoltage

    $379 (Avg Bid)
    $379 Avg Bid
    13 bids

    Need to design a cover photo and profile picture for facebook including information below. Logo attached - that is all I have, please use font that is VERY SIMILAR. Must also be able to be used on mobile phone view. Inner Performance Management 'Learn to Manage Stress Before it Manages You' IPM: Corporate, Sports & Performance [url removed, login to view]

    $17 (Avg Bid)
    $17 Avg Bid
    26 bids

    Hello, I need to create a simple Logic level 2 outputs and 1 output for LOW/normal battery sensor using the PIC688

    $24 (Avg Bid)
    $24 Avg Bid
    15 bids