Microprocessor jobs

Filter

My recent searches
Filter by:
Budget
to
to
to
Skills
Languages
    Job State
    697 microprocessor jobs found, pricing in USD

    ... devices, protocols, technologies and tools to implement the solution in line with the IoT solution architecture Requirements: • Experience in Designing with 8/16/32 Microprocessor / Microcontroller . • Familiar in various communication Interfaces like RS232, RS485, USB, I2C , SPI, SATA, PCI etc. • Familiar in Schematics entry using Orcad 16.6,

    $626 (Avg Bid)
    $626 Avg Bid
    11 bids

    I've used Arduino board and Pulse sensor to measure heart beat per minutes and calculate heart rate var...I'm looking for help are the following: 1. Upload heart rate variability to the cloud (any cloud service provider) using WiFi shield or through connecting Arduino to any microprocessor that has built-in WiFi capability (preferably Raspberry Pi 3)

    $156 (Avg Bid)
    $156 Avg Bid
    32 bids

    Hi, Need the completed project in 36 hours. Share the codes in 24 hours and the report in 36 hours. Project details are attached here. Sample codes are attached in the files. You need to use the similar codes for the work

    $100 (Avg Bid)
    $100 Avg Bid
    3 bids

    I've used Arduino board and Pulse sensor to measure heart beat per minutes and calculate heart rate var...I'm looking for help are the following: 1. Upload heart rate variability to the cloud (any cloud service provider) using WiFi shield or through connecting Arduino to any microprocessor that has built-in WiFi capability (preferably Raspberry Pi 3)

    $150 (Avg Bid)
    $150 Avg Bid
    1 bids

    ...I'm looking for help are the following: 1. Upload heart rate variability to the cloud (any cloud service provider) using WiFi shield or through connecting Arduino to any microprocessor that has built-in WiFi capability (preferably Raspberry Pi 3) 2. Develop android mobile-based app to visualize the loaded data (heart rate variability, heart beat per

    $616 (Avg Bid)
    $616 Avg Bid
    36 bids

    Άλλο ή όχι σίγουρος Άλλο ή όχι σίγουρος I want a Funduino Uno (Rev3) program. Funduino has a ATmega328 microprocessor and I want to do the following -Set a temperature by buttons - trigger a relay that open a small heater -When the te...

    $58 (Avg Bid)
    $58 Avg Bid
    4 bids

    ...messages. There needs to be 2 tones/sounds that are activated for either correct functioning or for errors. The system should be pre connected and tested including the microprocessor, display unit, EC and pH sensors and parastilic pumps. Low error margins for sensor readings and amount of pumped solution is key. There needs to be about 6 to 8 parastilic

    $968 (Avg Bid)
    $968 Avg Bid
    2 bids

    Hi Walid A., I noticed your profile and would like to offer you my project. We can discuss any details over chat. i have exam on microprocessor and i want you to tutor me through skype. please let me know

    $15 / hr (Avg Bid)
    $15 / hr Avg Bid
    1 bids

    ... a microprocessor board, and an FPGA board. With this system, a PC application allows a user to “awaken” (or “start up”) the FPGA board through the microprocessor board. Once (and only after) the FPGA board is awakened, it waits for a push button action. After the button is pushed, it sends an 8-bit value in bit-serial to the microprocessor. Th...

    $42 (Avg Bid)
    $42 Avg Bid
    9 bids

    ...multiple phases. It is to develop a logic analyzer and waveform viewer (LA/WV) that can send data to a PC for display. The data collection is done on the FPGA board. A microprocessor gets data from the FPGA board and sends data to the PC through either a Bluetooth modem or a USB port. The system supports one analog channel and one digital channel,

    $72 (Avg Bid)
    $72 Avg Bid
    2 bids

    The data collection is done on the FPGA board. A microprocessor gets data from the FPGA board and sends data to the PC through either a Bluetooth modem or a USB port. The system supports one analog channel and one digital channel, with a single-level triggering. Only 8 bits of precision will be used for the analog channel. •Phase 1: Develop a minimal

    $322 (Avg Bid)
    $322 Avg Bid
    6 bids

    Need an experienced programmer with knowledge of microprocessor Budget-40$

    $31 (Avg Bid)
    $31 Avg Bid
    3 bids

    I have to solve some simple microprocessor tasks

    $17 (Avg Bid)
    $17 Avg Bid
    7 bids

    ...board using two jumper wires for data transfer and one wire to connect their grounds. Write codes that allow the microprocessor to use one wire to send a bit over to the FPGA which inverts the bit and sends it back to the microprocessor using the other wire. The bit value to be sent out from the UNO should be input from the serial monitor while the

    $10 (Avg Bid)
    $10 Avg Bid
    1 bids

    I need to develop program for Rabbit 3000 platform using RCM3000 module or similar. Module should receive and transmit commands to peripheral device through one of UART ports. Also module should to transmit the some data by Ethernet to host. Software is Dynamic C.

    $447 (Avg Bid)
    $447 Avg Bid
    8 bids

    Hi, I need help on my project with Arduino. The goal is to connect Arduino Uno module to Tex...CC1101 radio transreceiver module. The connection is over SPI Interface. If possible existing Arduino SPI libraries should be used. I have an example project where Atmel Avr microprocessor is used to connect to CC1101, would like to do the same with Arduino.

    $39 (Avg Bid)
    $39 Avg Bid
    15 bids

    I need you to write some content for a website. My project is how to develope microprocessor

    $24 (Avg Bid)
    $24 Avg Bid
    11 bids

    Hi Hassan A., I noticed your profile and would like to offer you my project. We can discuss any details over chat. it is in microprocessor

    $40 (Avg Bid)
    $40 Avg Bid
    1 bids
    embedded systems 1 Ended
    VERIFIED

    ...board using two jumper wires for data transfer and one wire to connect their grounds. Write codes that allow the microprocessor to use one wire to send a bit over to the FPGA which inverts the bit and sends it back to the microprocessor using the other wire. The bit value to be sent out from the UNO should be input from the serial monitor while the

    $30 (Avg Bid)
    $30 Avg Bid
    2 bids

    ...board using two jumper wires for data transfer and one wire to connect their grounds. Write codes that allow the microprocessor to use one wire to send a bit over to the FPGA which inverts the bit and sends it back to the microprocessor using the other wire. The bit value to be sent out from the UNO should be input from the serial monitor while the

    $152 (Avg Bid)
    $152 Avg Bid
    3 bids

    Top microprocessor Community Articles