Closed

MSP430 Target Board to S7366R Project.

This project was awarded to Zibsnis for $99 USD.

Get free quotes for a project like this
Employer working
Awarded to:
Project Budget
$30-$250 USD
Total Bids
6
Project Description

This the project needs to be composed on latest release for IAR Systems\Embedded Workbench from Texas Instruments. The MSP430F2013 CPU has 16-bit RISC architecture that is highly transparent to my application.

Result: C code written for MSP430F2013 target board (Web Site: [url removed, login to view]) that zipped to single file (including project configuration for IAR).
This file must contain all files to be able to open with IAR Systems, Embedded Workbench from Texas Instruments (comes with ez430 USB KIT. Web site: [url removed, login to view]).
I need to develop the interface (most likely I2C and SPI combination) from MSP430 Target Board to LSI_CSI 32-bit Quadrature Counter with serial interface ([url removed, login to view] ) .

I will supply all hardware! I will need your address for this shipment.

I will need code to support up to 3 counters (LS7366R) remotely (with chip select selection) from Daughter Board (MSP430 Evaluation Board EZ430-T2012). The issue here is that the LSI counter will have unknown value (LSI has separate power supply and most of the time will be ON) in counter register for each single power up for Target Board (ez430). The register in microcontroller that will be holding internal virtual counter that will be with reset feature that set value to zero. The actual count in virtual counter goes both directions to positive numbers from zero and to negative from zero while the value in LSI counter is always goes in positive numbers to max value and back to zero (closed loop). The additional feature: scaling counter. The scaling ratio should be available to convert the value from virtual counter to scaling counter. Another feature: the interrupt signal from LSI counter IC should be configured to initiate the communication. Since the address for Chip Select signal will be configured with I/O port the address protocol needs to be initiated first to be able to access to corresponding LSI counter IC.
Prior that the I/O port will be used to request the address of interrupt. The LSI counters will count without any communication with MSP430 and microcontroller will read the value upon interrupt from LSI counters in order the interrupt was received. On power up the LSI counter IC should be checked for complete configuration. If configuration does not match to default, the configuration has to be run over on all LSI counters prior all algorithms are activated.
[url removed, login to view]
USB Stick EZ430-F2013
Daughter Boards: MSP430 Evaluation Board EZ430-T2012
[url removed, login to view]
I have already some code developed for this Daughter Board. I also have already developed and tested Display Module hardware working with C code. All I need is to add new feature, to be able to read the data from remote Counters (LSI). Microcontroller on MSP430 Evaluation Board, MSP430F2013TPWR, already works perfectly with up to 3 Display Boards to indicate the value of the internal Counter. But I need to develop one more interface to LS7366R. I will send all hardware prior release of finalized code with all features. But at the beginning we will work on hardware I have. We also need to develop the concept prior I build an additional prototype.

Looking to make some money?

  • Set your budget and the timeframe
  • Outline your proposal
  • Get paid for your work

Hire Freelancers who also bid on this project

    • Forbes
    • The New York Times
    • Time
    • Wall Street Journal
    • Times Online