Completed

Raspberry PI software development

This project was successfully completed by axos88 for $600 USD in 10 days.

Get free quotes for a project like this
Employer working
Completed by:
Project Budget
N/A
Completed In
10 days
Total Bids
6
Project Description

The project will be run on a Raspberry Pi. The project will use the UART GPIO pins of the Raspberry Pi or its USB ports to communicate to external devices using the Modbus RTU RS485 protocol. The software should be a GUI to simplify setup. The GUI should enable the user to specify the Modbus slave ID's of devices to read information from, allow the user to specify the register addresses to read from each slave device, and set up registers on the RPi to store the read values into. It should also allow setup of the modbus communication parameters. The GUI will reside on the Raspberry Pi, but need to be accessible remotely via the internet.
The software should also set up the Raspberry Pi as a web server. Stored values should be read from the RPi using a HTTP command, i.e., http://RPi_IP/[url removed, login to view],R,fmt Where [url removed, login to view] will be a function stored on the RPi to read the register number (R), using the number format (fmt). Number format can be INT or REAL.
Data that is read from the modbus devices should be stored on the RPi. An additional register should be set up for each value stored so they can be averaged over a 15-minute interval. The 15-minute interval values should then be written into a CSV file, which will be uploaded to a remote server every 24-hours.

Looking to make some money?

  • Set your budget and the timeframe
  • Outline your proposal
  • Get paid for your work

Hire Freelancers who also bid on this project

    • Forbes
    • The New York Times
    • Time
    • Wall Street Journal
    • Times Online