Digital Signal Processing Jobs

I need a seasoned embedded engineer to design and implement a lean Time-Division Multiplexing protocol that funnels several high-speed ADC channels into a single, reliable UART stream. The end goal is clear: squeeze the maximum possible throughput out of the link without sacrificing data integrity. The work revolves around three core competencies—TDM protocol development, raw ADC data handling, and low-level UART communication—so fluency in each of these areas is essential. Our front-end hardware already produces digitised samples via a bespoke analog-to-digital conversion stage; your task is to move those samples efficiently over UART, interleaving them with tight framing, minimal overhead, and built-in error checking. Key deliverables • Well-documented C/C++ (or equi...

I need a compact 2-4 channel analog MEMS microphone array built around an XMOS processor. The board must perform real-time beamforming, echo-cancellation and noise-suppression, then expose a clean audio output through straightforward header pins so it can be patched into downstream hardware without fuss. Size matters here: the smaller the PCB, the better. I’m expecting you to handle the full hardware cycle—schematic capture, PCB layout, component selection and a ready-to-order BOM—plus the XMOS firmware that brings the DSP features to life. Your code should compile and run on the free tools from XMOS; please include any scripts or tuning utilities you rely on. Deliverables • Production-ready Gerbers, pick-and-place file, annotated schematic • BOM with supp...

I need a concise Python 3 script that will run on a Raspberry Pi 5 and do the following: • Watch a single GPIO input line for the HIGH digital signal coming from my Sony camera’s built-in AI output. . The Sony camera will be pre-loaded with images of the target - in this case a plant which is detected in the target bounding box in the camera field of view. . When the target plant is encountered in bounding box of the camera field of view, the corresponding relay will activate a spray nozzle for the time the target remains in the bounding box. •The point above is achieved as soon as that digital signal is detected, drive a separate GPIO output that energises a small 5 V solenoid for as long as the target plant remains in the bounding box of the camera, then automatical...