Cancelled

CAN Bus Driver for STM32F4

Hi,

I'm looking for someone to help develop a CAN Bus Driver for a STM32F407VGT MCU.

I have the driver already written, but am running into Receiving issues.

In short, A request is made on the network, a module responds with about 145 messages sent in unison. The receiving node(The one i'm working on) only captures about 30% of the traffic sent. I have tried both looping on the CAN receive, and interrupts. Neither caputre all the traffic. (Typically captures first 2 frames then skips like 30 messages and captures a few more). I'm assuming FIFO overrun as I may not be getting the messages out quick enough.

I am a hobbyist, and this project is non-commercial. I will pay someone a flat rate to build a driver that works better or per hour if you are willing to tutor. (If you are willing to tutor I will pay higher fee)

Please message me for more details! I also have another project that need undertaking (ILI9340 SPI driver)

Thanks.

Skills: C++ Programming, Embedded Software

See more: stm32f4 can bus, stm32f4 can bus driver, can stm32f4, stm32f4 can, stm32f4 can driver, to bus, spi programming, node programming, i need a tutor for c programming, i need a programming tutor, c++ programming per hour rate, looking for a tutor, getting help for c++ programming, mcu, FIFO, fifo project, bus can stm32f4, project fifo, mcu programming, programming can bus, can bus programming software, bus can 18f458 project, need bus, stm32f4 project, can quick

About the Employer:
( 1 review ) Olathe, United States

Project ID: #5377122

7 freelancers are bidding on average $156 for this job

NikB

I need to see your code - maybe there is not so bad :) .

$111 USD in 5 days
(9 Reviews)
4.6
dragomirvw

Hello, I have experience with CAN bus communication. However, I do not have experience with the processor that you are using. I am not sure how I could help you, maybe I can make a code review of your code? Are you More

$100 USD in 60 days
(1 Review)
1.6
Krasutski

Hello, I can help! Please see my portfolio for have more details about my experience. Now I have board with STM32F407VGT , this greatly simplifies remote debugging. also I can help with (ILI9340 SPI driver) B More

$110 USD in 5 days
(1 Review)
1.4
GabrielSoare

I have experience with STM32F100 (STM32 Discovery board based on Cortex M3). In the past I have created from scratch UART and I2C protocols (those were implemented in software not hardware). I will implement the CAN pr More

$169 USD in 7 days
(0 Reviews)
0.0
rdbembsys

Hi, I have over 20 years of experience in embedded software design and development. pl. go through my profile portfolio which gives you a better understanding about my expertise. Look forward to next level communica More

$222 USD in 30 days
(0 Reviews)
0.0
manimuthukumar

I have more than 12 years of industrial experience in embedded system. I have worked on various projects and developed protocol, system software and Firmware for ARM and Microcontrollers. I have more than 12 years of More

$222 USD in 20 days
(0 Reviews)
0.0
thesilex

Dear sirs, I am working for a company that manifactures vehicle tracking systems. I am responsible for embedded software design. We are heavily using NXP LPC17xx microcontrollers on our tracker devices. I can convert C More

$155 USD in 3 days
(0 Reviews)
0.0