Hi Clyde, I've uploaded a corel draw file which has some text that will be going on the back of temporary tattoos. I'm also attaching a PDF version of the temporary tattoos (front and back) which shows measurements. The front of the tattoos in the PDF are the correct measurements but I need the backs to match. There are also a few spacing issues in the text. For example the TM in the logo is a bit far out on a few occasions. If you accept the project I can be more specific. I basically need the backs to look professional with not too much white space, i.e. the text should fill up most of the space.
Actually here are the specific changes:
Page 1 - Fine
Page 2 - Fine
Page 3 - The TM in the logo should be closer to the logo (looks like there is an additional space)
Page 4 - The TM in the logo should be closer to the logo.
Page 5 - Some spacing issues between the letters: In line 1., the word "free" has the letters too close together. The same in No. 5 for "off" and the same for No. 6 "effect".
The dotted lines don't go far enough out.
The text "We'd love to see a photo...etc" is missing.
Page 6 - Fine
Page 7 - Fine.
Page 8 - The image and the text at the back don't seem to have the similar measurements. Ideally I would like the text at the back of each tattoo to fill out as much white space as possible.
Page 9 - Same comment as for Page 8.
Page 10 - Same comment as for Page 5.
Page 11 - Same comment as for Page 5.
Page 12 - Fine
Page 13 - The TM in the logo needs to be closer to the logo. There is an extra space after "free" in No.1.
Page 14 - Fine
Page 15 - Fine
Page 16 - Same comment as for Page 8.