New GoGo Real USB Board

This project was successfully completed by tkousar for $400 USD in 10 days.

Get free quotes for a project like this
Project Budget
$250 - $750 USD
Completed In
10 days
Total Bids
Project Description

Design a new schematics and PCB layout for a GoGo Real Board.

This board was designed by me, but I not good with electronics. This board aims to control 4 motors, read 8 sensors, receive commands from USB. The board is powered with 8V/2A batteries. The motors can be set to receive 5v from regulator (the same that powers the pic) or 8v from batteries.

This board must be done with Cadsoft Eagle, Using a PIC18F4550 and smd layout.

The board must have:

- In-Circuit. Serial Programming ( ICSP )

- USB 2.0 connection

- control 4 DC motors using 2 L293B, each chip L293B will have a switch to choose 5v regulator or DC output from batteries

- 8 A/D channels for read sensors

- Use terminal block , 3way , [url removed, login to view] pitch Spacing, like the CTB9358/3 at [url removed, login to view]

- One reset button

- One simple button

- One led or RGB led.

- One piezo beep

- I2C connection.

There are many improvements that can be done, any suggestion for improvement is welcome.

Completed by:

Looking to make some money?

  • Set your budget and the timeframe
  • Outline your proposal
  • Get paid for your work

Hire Freelancers who also bid on this project

    • Forbes
    • The New York Times
    • Time
    • Wall Street Journal
    • Times Online