RMS detector 1Hz-500MHz, [url removed, login to view] error, -90dBm to +10dBm (2)

In Progress

Sorry I have to re-post this project, as the logic of this site does not seem to allow a freelancer to lower her bid after the bidding deadline - even if this is due to project clarification and has been communicated in PM's. So here we go again...

We need a custom schematic design ready for layout, which can implement an RMS level to DC level converter for detecting a signal amplitude with an A/D converter.

Input frequency: 1 Hz to 500 MHz

Input range: -90 dBm to +10 dBm

Accuracy: 0.1 dBm

Board size: max 100 mm by 50 mm

Power source: USB

The device is a simple analog in, analog out detector for measuring RMS value of a small signal in the frequency range 1 Hz to 500 MHz. With the input signal applied at the input, the output should be a DC voltage in the range of 0V to about 3V for feeding into a suitable A/D converter. The A/D converter is not part of the detector, but suitable types may be suggested.

A more detailed requirement document is attached.

USB power is optional - if you can make it work on USB power, you have a much better solution. But feel free to suggest a solution that requires maybe [url removed, login to view] DC plus less than some number of mV AC ripple up to some frequency if you want. I will consider that as well.

For accuracy or linearity, the important thing is really being able measure the whole range of -90dBm to +10dBm with a resolution of [url removed, login to view] both in terms of absolute and relative accuracy.

This may require calibration - preferably build in and automatic. And it may require a table/function to translate from the output voltage to the measured input level. That is perfectly okay and the table/function would then be implemented outside of this project on a PC.

You acknowledge and agree that all works of authorship included in this project, shall be considered "WORKS MADE FOR HIRE" and that all ownership in such works shall vest entirely to me.

You agree to assign and deliver to me the entire rights, designs, related documentation, title and interest in this project and all copyrights.

Four steps are defined for this project:

1) Schematic ready for layout

2) Layout

3) Functional prototype

4) Verification test

Please bid for the first step only along with individual estimates (time and money) for the remaining 3 steps.

Skills: Electrical Engineering, Electronics

See more: rms detector, want to works as freelancer, want to hire in freelancer, verification freelancer, translate for money freelancer, translate for money, to to freelancer, the site to hire freelancer, the prototype part 1, ripple freelancer, resolution engineering, prototype part 2, prototype freelancer, prototype engineering for hire, power up 2, power part 2, power of the freelancer, power electronics freelancer, plus size freelancer, part time electrical design, max size for freelancer, i want to translate for money, i want to hire a freelancer, i want to be an electrical engineering, it engineering freelancer

Project ID: #2330039

Awarded to:

MikroStar

hi, i can help.

€300 EUR in 30 days
(37 Reviews)
6.0

5 freelancers are bidding on average €250 for this job

MIKY4227

hi please see portfolio

€250 EUR in 10 days
(14 Reviews)
4.8
CompuIIT

I have used the Analog Devices AD636. Would the frequency response at -90 dBm be suitable?

€199 EUR in 8 days
(1 Review)
2.4
faizankhalid

I can do this.

€250 EUR in 21 days
(0 Reviews)
0.0
copertronic

We are expert in design with microcontroller ATMEL,MICROCHIP.

€250 EUR in 8 days
(0 Reviews)
0.0