USB Microntroller project



We need someone experienced in Micro-controller programming to write software to interpret input from a USB HID and use this to control a device that requires a serial protocol. So in essence when the user presses up, an LED is lit and the direction sent over Serial. We do own a smartos USB Stack if that is required, but this project may be easier at low level. I am open to all suggestions including the MCU to use, our preferred MCU is the STM32 range of ARM devices as we have most experience with this. We have full debugging capabilities and have a LeCroy Voyager M3i for debugging the USB protocol if required (This device will NOT be sent to the bidder but we can run code locally to assist in debugging)

Skills: Electronics, Embedded Software, Microcontroller

See more: lecroy voyager m3i, lecroy, c++ usb programming, usb hid, stm32, microcontroller c programming arm, mcu, LIT, full stack, arm microcontroller c programming, microcontroller software code, smartos, usb control software, programming arm microcontroller, device controller, micro arm, code software microcontroller, usb serial control, device protocol, programming usb, hid code, mcu programming, micro project, usb hid code, code protocol stack

Project ID: #4401867