Private project to set direct with freelancer. Thank you for your interest. This is direct with pre selected resource. Thank you again for your interest.
This project was awarded to
Looking to make some money?
- Set your budget and the time frame
- Outline your proposal
- Get paid for your work
Bids on this Project
Electronic designer for both analogue and digital design. Deeply experience gained in many year as electronic designer for the main defence industries. Technology: - analog from DC to 500MHz (signal conditioning, conversion and buffering) - Digital, extensive use of micro-controller, microprocessor and DSP. Deep knwolodgement of FPGA application I can specify, design develope a project, I can built both prototype and production. I can test it and design the test station. I can help the customer to fully qualify the design according to CE marking or any military test.
I am an electronics engineer with more than 7 years of experience in simulation, embedded applications and electronics.
I'm a teaching assistant at faculty of engineering Cairo university, at Egypt. I'm specialized at control , embedded systems (Microcontrollers),electronics , power electronics and Automation( PLC ,Scada and DCS) , also i'm working on nonlinear control , fuzzy and interval type 2 fuzzy.
We are ready to start working on your Arduino and C++ Programming jobs and projects. We have been working as a Arduino Engineer and C++ Programming Programmer and have great skill and experience in these areas. We also have great experience in the areas of Debugging and Editing as I have worked as a Debugging Expert and Editing Expert. I have good skills in the area of Education & Tutoring. As we have a professional outlook and warm approachable nature we can fit best for your job if hired.
We offers design outsourcing solutions for the Engineering and Architectural Industries. This includes conversion of legacy data as well as providing analysis, optimization and visualization solutions. We is focused on building intellectual property in the above fields, which can be leveraged to add value to our clients.
Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of hardware For each concept descriptions are as follows: Digital Motor Control: -3-phase induction motor vector control drive -Flux estimation algoritm generation -DSP(TMS320) implementation on motor drive -Low speed application -Torque and speed loop generation -Control algoritms Analog design -Low power distribution -Noissless special opamp based analog circuits -Analog filters -Orcad simulation of several circuits Electronic Design -RF transmitter and receiver -Bluetooh reader and transmitter -Magnetic reader Power Electronics -Implementation motor drive -AC/DC converter -DC-DC converter -Battery charger -Solar inverter -Renewable Energy simulations -Uninterruptle power supplies PCB design -Schematic design by Altium -PCB design by Altium -Power board design -SMPS board design Embedded system -PIC18,PIC24,PIC30 and dsPIC applications -Ardino -MSP430 -Atmel -DSP(Texas Instruments) -Renesas Matlab -Power Electronics simulation -Motor drive -Wind Energy -Solar Energy -Control applications Simulation of Hardware -Orcad Simulation(TI,National, Linear Tech, Maxim libraries) -LTI -National -Matlab