Finish some program in MathLab - 20/03/2017 16:59 EDT

This project received 16 bids from talented freelancers with an average bid price of $99 USD.

Get free quotes for a project like this
Project Budget
$10 - $30 USD
Total Bids
Project Description

Calibration pattern "design". Generate data of a "virtual" 3D cube similar to the one shown in Fig. 1 of the lecture notes in camera calibration. For example, you can hypothesize a 1x1x1 m3 cube and pick up coordinates of 3-D points on one corner of each black square in your world coordinate system. Make sure that your data is sufficient for the following calibration procedures. In order to show the correctness of your data, draw your cube (with the control points marked) using Matlab. I have provided a piece of starting code in Matlab for you to use.

"Virtual" camera and images. Design a "virtual" camera with known intrinsic parameters including focal length f, image center (ox, oy) and pixel size (sx, sy). As an example, you can assume that the focal length is f = 16 mm, the image frame size is 512*512 (pixels) with (ox,oy) = (256, 256), and the size of the image sensor inside your camera is 8.8 mm *6.6 mm (so the pixel size is (sx,sy) = (8.8/512, 6.6/512) ). Capture an image of your "virtual" calibration cube with your virtual camera in a given pose (R and T). For example, you can take the picture of the cube 4 meters away and with a tilt angle of 30 degree. Use three rotation angles alpha, beta, gamma to generate the rotation matrix R (refer to the lecture notes in camera model). You may need to try different pose in order to have a suitable image of your calibration target.

Direction calibration method: Estimate the intrinsic (fx, fy, aspect ratio a, image center (ox,oy) ) and extrinsic (R, T and further alpha, beta, gamma) parameters. Use SVD to solve the homogeneous linear system and the least square problem, and to enforce the orthogonality constraint on the estimate of R.

i. Use the accurately simulated data (both 3D world coordinates and 2D image coordinates) to the algorithms, and compare the results with the "ground truth" data (which are given in step (a) and step (b)). Remember you are practicing a camera calibration, so you should pretend you know nothing about the camera parameters (i.e. you cannot use the ground truth data in your calibration process). However, in the direct calibration method, you could use the knowledge of the image center (in the homogeneous system to find extrinsic parameters) and the aspect ratio (in the Orthocenter theorem method to find image center).

ii. Study whether the unknown aspect ratio matters in estimating the image center, and how the initial estimation of image center affects the estimating of the remaining parameters. Give a solution to solve the problems if any.

iii. Accuracy Issues. Add in some random noises to the simulated data and run the calibration algorithms again. See how the "design tolerance" of the calibration target and the localization errors of 2D image points affect the calibration accuracy. For example, you can add 0.1 mm random error to 3D points and 0.5 pixel random error to 2D points. Also analyze how sensitive of the Orthocenter method is to the extrinsic parameters in imaging the three sets of the orthogonal parallel lines.

In all of the steps, you should give you results using either tables or graphs, or both of them.

Skills Required

Looking to make some money?

  • Set your budget and the timeframe
  • Outline your proposal
  • Get paid for your work

Hire Freelancers who also bid on this project

    • Forbes
    • The New York Times
    • Time
    • Wall Street Journal
    • Times Online