-integrate inlet at window
-cover of inlet on side elevation
-sharpen divider line
-narrow exhaustion pipe (rear)
-modify wheelbase and overall length of car SLIGHTLY - see attached
before you render it with all these changes please send me DWG and STL file!!
I realize that it is a different angle and that it is still unfinished, but just wanted to clear out a couple of things I noticed to save you time. The side vent should have an additional cover as otherwise you will have a big problem with the radiator intakes on the side. the cover should be done to cover the holes on the side because as it was the vent would be only a couple of inches away from the rear wheel. I also noticed the intake near the windows is missing and the shape of the windscreen was a bit strange. also the front splitter should be integrated.
for the narrowing of the exhaustion pipe i did not attach a file because you have the rear rendering
again if in doubt look at the original 2d renderings I sent you and refer to them..
great job its going where want to!