Closed

CAD Design (simple 3D gear/magnet prototype)

This project was awarded to cadfreak for $30 USD.

Get free quotes for a project like this
Employer working
Awarded to:
Project Budget
$30 - $50 USD
Total Bids
13
Project Description

Small project requiring a mock up of a magnetic motor concept.
animation would be nice but not required. Perhaps just a single rotation to provide understanding of mechanics involved. Project is a 3D rendering w/ short animation to show how it works. Single 3/8" shaft with a 6" wheel containing a number of high strength .5" x .5" x .25" magnets rotating with a static clear outer cylinder 8" inner diameter that also has high strength magnets of the same size as inner wheel. There will be a solonoid and a reed/magnetic switch that is used to lower/raise a soft iron wedge between each of the magnets as they pass one another. I need this mechanical shield created (use your imagination) Mock up can be either 6, 8 or 12 magnets on the sheel/rotor and outer cylinder, whichever is easier allowing good visibility. This project is just to provide a pretty mock up of how the device works. Sizing/dimensions do not need to be specific. Non-professional drawing and 2D renderings are available to give general description of what 3D rendering/animation should look like. More of a concept demonstration of a magnetic motor w./ housing and solenoid actuated magnet shielding apparatus that comes down into the magnet field as the magnets rush by one another. Shield then moves out of the way to allow the push/pull of the magnets.

Looking to make some money?

  • Set your budget and the timeframe
  • Outline your proposal
  • Get paid for your work

Hire Freelancers who also bid on this project

    • Forbes
    • The New York Times
    • Time
    • Wall Street Journal
    • Times Online