Cancelled

Structural Engineering Conservatory Framework

I have a pre-lim designed sketch of a conservatory style room using I-Beam framing, with aluminum slider doors inserted into the frame. A simple Steel framed roof with 2-3 degree slope and 5 rib zinc (or equiv). I need specific drawings for council submission. The drawings produced will need to be signed off by a structural engineer in New Zealand, however, due to the Christchurch Earthquake, the chances of small jobs like this will get pushed back 6 months which I do not want to wait.

I want to over-emphasise the steel and therefore should have no problem with load bearing but I do need the calculations and how they should fit together.

I am open to interpretation and ideas as nothing is set in stone. The room is quite simple. Its a square box. On site already there is a "hideous" 1970's style, good for nothing, single glazed conservatory which I hate with a passion, This conservatory is sitting on a concrete pad (existing structure about 3 meters x 3 meters). One side of the conservatory pushes hard against a garage and the other side to the house, with an opening to a living space. I am wanting to increase the size of the "pre-existing" concrete pad by a few meters either side by drilling rods into the "pre-existing concrete slab and concrete blocking around and filling. There is a natural slope on site, however at lowest point to solid ground its 600 mm. I will need to show weather tightness of the structure which I just assume its as easy as taking cladding off the house, adding a rubber membrane between the steel and "wooden framing of the house" and recladding, however you may have some ideas around this. I am also not opposed to a completely "flat" roof using rubber, but I do not want it looking silly or terrible so again open to thoughts around this. I am sure you will have 50 more questions, please just ask

Skills: Structural Engineering

See more: structural engineer's, square jobs, sketch jobs, site engineer jobs, site engineering jobs, other engineering jobs, off sure jobs, need structural engineer, jobs the engineer, jobs structural engineer, jobs in new zealand, jobs in engineering, jobs engineer, jobs drawings, i want engineering, house sitting jobs, flat drawings, engineer jobs, engineering side jobs, engineering jobs jobs, engineering jobs in, engineer engineer jobs, drawings of jobs, drawings jobs, do i need structural engineer

About the Employer:
( 0 reviews ) dunedin, New Zealand

Project ID: #4527751

7 freelancers are bidding on average $36/hour for this job

hasance06

Please check your PM for details.

$27 NZD / hour
(13 Reviews)
4.2
victork2

Dear Sir, I am professional designer with over 15 years of experience. Willing to do this project for you. Best regards Victor

$22 NZD / hour
(1 Review)
3.8
c4chamod

-Engineering Solutions-

$55 NZD / hour
(1 Review)
2.2
khloud89

I'm a structural engineer with high experience in steel structures design. I read your post but in fact I'm still don't understanding what is exactly required. could you just write it in points 1,2,3 Regards, Khl More

$20 NZD / hour
(1 Review)
0.0
alaaelsisi

I can do it

$27 NZD / hour
(0 Reviews)
0.0
aarceng

Australian structural engineer.

$75 NZD / hour
(0 Reviews)
0.0
mkeden27

Regards, Civil engineer's here to Analyze any structures.

$27 NZD / hour
(0 Reviews)
0.0