Hello, I would like a Developer to develop a program for the Orange Pi 2G-IOT single board computer.
This is a very simple project in concept I don't know how difficult it may be. The Program Can be written for either Linux Or Android, as the SBC can run Android, Ubuntu, Debian, Raspbian [url removed, login to view] Program must be able to accept commands sent to it VIA SMS text message using the on board embedded cellular modem. It also needs to execute the commands by either telnet,ssh or http. The program also needs to be able to send SMS depending on the commands given.
Receive command "to get IP address from my internet modem" ( WIMAX modem dynamic ip changes on reboot or power loss.
The IP can be retrieved via WEB GUI HTTP browser, TELNET or SSH( far as I know)
After looking up the IP address the program sends the IP via SMS TEXT.
Receive Command "info changer"
this command tells the device via sms to open a terminal and telnet to the modem
an execute the specific telnet commands withing the text.
I don't know if my intentions are clear enough but I can provide extra details.
THE SPECIFICATIONS FOR THE SINGLE BOARD COMPUTER BELOW
ARM Cortex-A5 32bit
Separate graphic processor, Vivante's GC860
30M Triangle/s, 250M Pixel/s
Integrated 256MB LPDDR2 SDRAM
TF card / Integrated 500MB 8Bit 1.8V 4K SLC Nand Flash
The four frequency single card
GSM/GPRS Dedicated accelerators
A CSI input connector Camera
Supports 8-bit YUV422 CMOS sensor interface
Supports CCIR656 protocol for NTSC and PAL
Supports SM pixel camera sensor
Supports video capture solution up to 1080p@30fps
MIC, 3.5 mm Jack
3.5 mm Jack, FM, SPEAK（Optional）
USB OTG can supply power
Battery input can supply power（Optional）
USB 2.0 Ports
One USB 2.0 HOST, One USB 2.0 OTG
40 Pins Header,compatible with Raspberry Pi B+
Android, Ubuntu, Debian, Raspbian Image