I am a craftsman and I need to design a very special profile meter for hand crafted curve on a woodwind instrument. I have some product development experience and need someone who can integrate these tiny sensors with a low cost microprocessor that will give me the ability to drive 25 simultaneous 3 segment LED digital read outs. The system will have to have dead on accuracy up to .001 (one thousandth of an inch). We may have to consider programming a calibration mode. Each sensor will have a tiny probe above it which will vary by about 3 mm.
28 freelancers are bidding on average $139 for this job
Hello, I've good experience designing electronic devices and sensor integrations, can you send me more details about the sensor that you want to use? Let me know if you have any questions. Best regards,
Hello. do you need circuit design or program? I have many experiences with MCU(atmega, PIC, 8051) And I am engineer about PCB design. can you explain details? Regards.