LoRa mesh code for RFM95 under ESP32 Arduino
Budget €30-250 EUR
I need Arduino software code for LoRa mesh network using RFM95 & ESP32.
Only SW not HW!!
NOT Peer to Peer communication!!! I need tree or mesh network.
You must have RFM95 & ESP32 for testing and debug in your side.
Test will be done using 4 devices at the same time and disconnecting and reconnecting them.
The sender device will receive the OK if the message was properly received from receiver.
Test for GPIO2 remote control should be integrated.
Configuration parameters indicated as #DEFINE.
Message to be sent will be set later.
LoRa Frequency in my side: 868MHz
5 freelancers are bidding on average €206 for this job
Hello Sir, I have good experience in Arduino with having more than 7 years experience in this field also I read your project description and I am interested in it but still we need some more information Can we discuss More
Hi there, I have a great experience with esp as I have made a lot of projects using it. And I have made a project based on lora technology, I have made a gateway using raspberry pi and rak831 and a node using Arduino a More
Ready to start right now!! I am a senior developer. I can do it for you if you want. Let me discuss about this project if you want. I am ready to do it for you. I think its very easy project for me. So just reply to di More
I have 2+ year experience in Arduino based iot automation projects.i will like to do this project. i have lot of interest in this project because already I done similar projects like this..I need some requirements from More