Need a firmware developer for ESP32 coding with pressure sensor
Budget $10-30 USD
Job Description:
I need to develop pressure sensor based coding for ESP32 mcu. Here, I am planning to use US9111 pressure sensor with mcp3421 ADC converter. I want to measure +5PSI to -5PSI pressure value, with auto zero calibration. When there will no pressure on the pressure sensor that must be zero value at the initial condition. It should be strictly maintain. It can be set by auto zero calibration. I want to measure pressure precisely, so you need to do the coding with exact calculation.
13 freelancers are bidding on average $65 for this job
Hi There, I am a senior Ph.D. Level Expert and Have more than 5 years of experience in electronics and embedded design. I have working experience with esp32 and can interface sensors as well. Just check my profile and More
As a skilled product development engineer with experience in designing and coding pressure sensors, I am confident that I can provide you with the solution you need. I have a deep understanding of microcontroller syste More
Hi! I have understood your requirements about your project with every detail of it. I am an Electrical Engineer with more than 9 years of experience in electronics, circuit design, PCB layout, Verilog, FPGA, Embedded s More
Hi, i would like to know which model of US9111 you are using.. as there are sensitive types and not so sensitive.. if you are using a correct model that can actually detect that range then i see no problem. seems simpl More
I already know what to do, this code initializes the I2C bus and the ADC, and sets the ADC configuration to start the conversion. The ADC data is read and converted to a pressure value in PSI. The auto zero calibration More
1)Developed pressure sensor based coding for ESP32 mcu 2)US9111 pressure sensor with mcp3421 ADC converter 3)measured +5PSI to -5PSI pressure value, with auto zero calibration 4)there will no pressure on the pressure s More
Electronic Engineer with +2 years of experience designing and developing hardware and firmware. Efficient and quick deliver of project. I have worked with various microcontrollers and created PCB's for medical and auto More
Dear client, I am a Computer and Communications Engineering student with a strong background in firmware development. I am writing to express my keen interest in your project. With my expertise in firmware development More
As an embedded systems engineer with over 1.5 years of experience, I have a strong background in developing and implementing various solutions for microcontroller-based systems. My expertise in this field allows me to More
