Closed

Firmware Development - STM32 Primer2

INTRODUCTION

The purpose of this document is to define the high level requirements for a firmware

development project of a sensor data collection system based on STM32 Primer 2 and ST

MEMS sensors.

This project description intends to define a design for a complete firmware, ready-to-use

for demonstration, operating on a system built from STM32 Primer2 and MEMS

accelerometers. The accelerometers are low-power 3-axis linear accelerometers with

digital output. The foreseen firmware needs to run an STM32 Primer2 device connecting

the sensing elements via an I2C interface, capable of translating information from a

numbeDesign Principles

This section provides the design principles with reasons driving these principles.

- Simplicity

-- Very simple, if possible the simplest solutions are preferred.

- I2C Bus

-- For the communication between the STM Primer The usage of I2C bus is flexible printed circuit board is required.

- Portability

The preference it to create a firmware, which is portable between STM32 and ST7

microcontrollers (both present on the STM32 Primer2 development platform)

Scope of Work

The following activities are in scope:

- Connection of Sensor

-- via Add-On Module [5] or

-- via breakout boards of MEMS sensors connecting to the E14 extension

connector of STM32 Primer2, similar to [6] (Please note, that this is a

different type of MEMS, although suitable for I2C integration development)

- Firmware development

- Testing

SCOPE

The following activities are out of scope:

- Application development

The following activities are limited to the necessary extent:

- Electronic advice, design and verification with regards to SMT32 Primer2

The following activities may be extended to the necessary extent:

- Advice on electronic design and verification with regards to replacing SMT32 Primer 2 with SMT32 Primer1

- Advice on electronic design and verification with regards to replacing the SMT32

Primer2 with an Atmel AVR based solution

... DETAILED PROJECT DESCRPTION ATTACHED

Skills: C Programming, Electronics, Microcontroller, Scientific Research

See more: stm32 primer2, stm32 i2c, stm primer, primer2, stm32 project, stm primer scope, stm32 primer, stm32 firmware development, simplest stm32 primer project, stm32 primer i2c, stm32 scope, smt32 primer2, smt32 primer, work translating, translating work, system sensor, principles elements design, primer design, power electronic design, scope requirements, elements principles design, driving connection, different digital design limited, design verification testing, design elements principles

About the Employer:
( 0 reviews ) Singapore, Singapore

Project ID: #537974

15 freelancers are bidding on average $1632 for this job

stemtechnologies

We are a group experienced embedded engineers working on hardware and software projects. We can do you project. We have given more info in the PM Regards Somasundaram.I

$1500 USD in 60 days
(1 Review)
4.4
suman12

pls. view PM

$1500 USD in 45 days
(0 Reviews)
0.0
dheerajkatarya

We have developed many application , device driver ,I2C driver on Linux platform If interested i can share demos of my previous work

$2000 USD in 30 days
(0 Reviews)
0.0
EwenF

I have many years experience designing with accelerometers from several manufacturers including ST LIS3L02 and LIS344AL. The I2C interface is also no problem.

$2000 USD in 30 days
(0 Reviews)
0.0
tipu04

I am well experienced in serial bus interfaces and can implement it on ARM .

$975 USD in 20 days
(0 Reviews)
0.0
aprajam

I have exp with firmware development for micro controllers. I have good exposure to I2C and have implemented I2C protocol in firmware for powerpc processor and also 8051 micro controllers.

$1500 USD in 40 days
(0 Reviews)
0.0
dancu

Dear Mr. Gelencser, I just finished my work as junior research assistant at the Embedded Systems Laboratory of National University of Singapore. I have just signed up on this site and have no feedback yet, but I woul More

$1400 USD in 30 days
(0 Reviews)
0.0
dsatya

Hello, We are a team of experts in system level product engineering services and we help customers with concept-to-manufacturing services. We have in-house electrical engineers, system architects, pcb lay out desi More

$3000 USD in 30 days
(0 Reviews)
0.0
Maryvale

Hi, I'm very interested in your project. Please see the PM. Thanks.

$1500 USD in 21 days
(0 Reviews)
0.0
henryjr

Dear Srs.. I m Expert in microcontrollers and embedded systems... please contacte for determinate the specific job. thanns

$3000 USD in 60 days
(0 Reviews)
0.0
rapidsoft

Rapidsoft Systems is an outsourced software product development company based in Princeton, New Jersey with software development activities in the USA and India. We are a foremost outsourced software product company wi More

$1500 USD in 30 days
(0 Reviews)
0.0
dasanupam

i think i can able to do that.

$1700 USD in 120 days
(0 Reviews)
0.0
freshmind123

Please check PM. regards

$999 USD in 30 days
(0 Reviews)
0.0
makinmakin

See details in MB.

$1000 USD in 25 days
(3 Reviews)
4.5
fathahrahman

Please see the PM and project clarification board

$900 USD in 30 days
(0 Reviews)
0.0