Closed

Freescale Coldfire MQX low power mode

I require some code that I can integrate into an existing MQX project to enable low power stop mode, and have the device wake again when an external pin interrupt is received. The code should be targeted to Coldfire V2 processors, specifically the MCF5225x. This should preferably done in C through the MQX RTOS, although inline assembly may be used where necessary.

I also need code to shut off unused peripherals or other processor subsystems (both in stop and run modes) to conserve power. Please write "I am real" at the top of your response.

Thank you

Skills: C Programming, Electrical Engineering, Electronics, Embedded Software, Microcontroller

See more: assembly inline coldfire, mqx low power, mqx power modes, coldfire low power, freescale mqx power modes, coldfire mqx, programming in assembly, c programming power, freescale coldfire low power, low power mode mqx, coldfire low power mode mqx, power, mqx, mode, low, power power, wake, programming electronics, programming assembly, pin code project, need used electronics, power supply low cost, rtos used, processors, peripherals

About the Employer:
( 1 review ) Mississauga, Canada

Project ID: #1258067

4 freelancers are bidding on average $219 for this job

sandeepe86

I am real Hi I knows this product family . I will definitively do this project in quick time.

$200 USD in 10 days
(0 Reviews)
0.0
printech8

I have huge experience in various microcontrollers. I can help you implementing your reqirements. Please contact for further discussions.

$225 USD in 6 days
(0 Reviews)
0.0
binaryexe

Our team is expert in micro controller programming. We have experience in most of the peripheral.

$200 USD in 7 days
(0 Reviews)
0.0
ramig972

I am real Dear Sir, I'm Hands-on engineer with extensive experience in Embedded Systems and Real-time applications. I used to develope for the ColdFire when it was a Motorola product and used MQX when it was More

$250 USD in 10 days
(0 Reviews)
0.0