Closed

ATMEGA/Arduino -> GE CHIPCAP-D interface, Sketch writer

I have an Arduino UNO and am looking for a programmer to write an INTERRUPT driven serial read (pin 2). The application is to read data from the GE CHIPCAP-D sensor. A digital 10 bit manchester encoded packet (Start, Data, Stop, Checksum) I can provide remote access to a system that has the sensor on an arduino attached.

I have the technical paper but lack the skills to write the library to in essence have a simple function "getsensordata" followed by a line designating whether it is looking at the first line, or the second line (ANDed together in the end, but seperate digital pins now).

Its a one-wire type of output, and Ill accept any solution where I type getsensordata(pin) and I get a meaningful result.

Preferably code written in Arduino as opposed to assembly

I imagine this wont take more than a few hours but you the professional, you tell me.

Skills: C Programming, Embedded Software, Microcontroller, Software Architecture

See more: chipcap, arduino chipcap, chipcap arduino, chipcap code, sketch atmega, arduino sketch writer, chipcap atmega, technical writer remote, system sensor, sketch programming, serial programming, programming remote, looking code writer, get arduino, ge sensor, remote programming, d programming, digital programming, data driven programming, data access interface, arduino uno programming, arduino uno microcontroller, system ge, sketch to, sketch application

About the Employer:
( 0 reviews ) San Diego, United States

Project ID: #1293310

5 freelancers are bidding on average $40/hour for this job

rajvigneshtn

I am an Embedded Research Engineer at British Physical Laboratories. I have exhaustive experience in all versions of Arduino. Visit my blog of projects: www.embeddeddronacharya.blogspot.com I also run a small size el More

$30 USD / hour
(5 Reviews)
4.1
reallifetech

See details in MB.

$32 USD / hour
(6 Reviews)
4.0
larsvaever

Hello I have a very large experience with AVR in generel and with arduino. I have made all sorts of hardware drivers for Nokia and others. I am new to freelancer.com but have worked on microcontroller projects t More

$70 USD / hour
(0 Reviews)
0.0
kamarn

I have experience embedded system developer...

$30 USD / hour
(0 Reviews)
0.0
RightAndAbove

Please see our PM.

$40 USD / hour
(0 Reviews)
0.0