Atmega Micro Controller Programming

HI I am experienced electronics engineer with more than 14 years of experience. I have read the details and have worked with CAN before. Please get in touch to discuss it further REgards

Hi I have lots of experience in Atmega controllers like Atmega , xmega 128, 1280, 2560..etc I do also have implemented a gateway like wifi to CAN, serial to CAN. I have used both built-in can peripheral as well stand More

Hello sir/ma, I'm interested in taking this task up for you. I am an Electrical Engineer with a masters degree and I have high proficiency knowledge in: FPGA firmware in VHDL and Verilog for Altera/Actel/Xilinx FPGAs a More

I read your project description , "C programming Micro Controller" carefully. I got your point I can do this project for you perfectly. I am more helpful in the success of each other and are careful in establishing a More

Hello, I am electronics and embedded systems engineer and TA as well. I can interface your Atmega with the PC through serial and a usb converter then interface the Atmega to other devices over a can bus. Contact me to More

Hello I have more than 15 years of experience in the embedded systems design and pcb design and electronics systems design So let's discuss your project in chat

Hello, thank you for your job posting. I read your description about--Microcontroller I am a senior electrical engineer. I have plenty of experience in firmware development and micro-controller developments. I can writ More

- previous experience in such topics; - eager to discuss a lot in this chat stream; - degree stats / maths;