Closed

Embedded C programming

Msp432 board

The “walk” button will be pushed by a pedestrian when he or she wishes to cross in any direction. To request a walk signal, a pedestrian must push and hold the “walk” button for at least 2 seconds, after which the person can release the button, and the walk request will be remembered. In contrast, when a car sensor is released, it means no cars are waiting to enter the intersection. You will use 8 outputs from your microcontroller that control the traffic lights, the “walk” light, and the “don’t walk” light. The “walk” light will be the green LED (P2.1) on the LaunchPad and the “don’t walk” light is the red LED (P2.0) on the LaunchPad. When the “walk” condition is signified, pedestrians are allowed to cross. When the “don’t walk” condition flashes (and the two traffic signals are red), pedestrians should hurry up and finish crossing in any direction. When the “don’t walk” condition is on steady, pedestrians should not enter the intersection. The red and green LED connected to P2.0, and P2.1 respectively must be used. All other inputs and outputs must be built on the proto-board.

Skills: C Programming, Embedded Software, Embedded Systems

See more: embedded c programming and the atmel avr, embedded c programming for microcontroller chapter 1, Embedded c programming, c# programming from problem analysis to program design, c# programming from problem analysis to program design pdf, embedded c++ programming, embedded c programming contractor, embedded c programming for avr microcontrollers, embedded c programming freelance projects, embedded c programming freelance uk, embedded c programming & microchip pic, embedded c programming pdf, embedded c programming tutorial, embedded c programming with the microchip pic pdf, 8051 embedded c programming examples, embedded c programming with 8051 pdf, embedded c programming examples with output, embedded c programming arduino, embedded c programming challenges, beginner's guide to embedded c programming pdf

About the Employer:
( 26 reviews ) Delhi, India

Project ID: #31914444

6 freelancers are bidding on average ₹2750 for this job

shaileshsannu

Hello l'm interested in your project. I'm electronic and communication engineer. I have 5 yrs experience in embedded system and it's designing. I have done many projects on industrial/home automation using u-controller More

₹2300 INR in 7 days
(6 Reviews)
2.7
Smartz64

Hi. I read the project discreption of your project and i how how this logic will be implemented using microcontroller. meet me , Having more than 3 years of experience in electronics designs, I will: - Help you to se More

₹2400 INR in 7 days
(1 Review)
1.0
etalhak

Hello, I am an electronics and telecommunication engineer. I am experienced in hardware and embedded systems' design. I have designed/printed/tested many PCBs and I also wrote many firmwares in C/C++ and I have checke More

₹5000 INR in 7 days
(2 Reviews)
1.2
(0 Reviews)
0.0
rahul5patel9

i am having more then 10 years of experience in Microprocessor & Microcontroller. i also have reach knowledge in field basic electronics,digital electronics ,power electronics,PCB Design, measurements and instruments , More

₹2300 INR in 1 day
(0 Reviews)
0.0
umesmishra

Dear sir , I have experience of programming this controller , understood your project very well , can do this project . waiting for your reply . Thanks and regards Umesh Mishra

₹2000 INR in 2 days
(0 Reviews)
0.0