You wrote some see code for me recently - Project title Cane Rev C
I have just a few questions about the code and I was hoping you could write a bit more code for me as well.
The first question I have is line 27 of the NAU 7802.C file.
Should that reset = 1 be there?
When performing function registerReset (0);
you have written code for reading any register
I tried this
newv = readRegister (0) but got unusual results.
What is best way of reading contents of a register eg 0x00 that has just been written to.?
Here is some extra work that needs doing.. Can you let me know cost?
To get current to load cell I need 3v3 to come from LDO in NAU7802.
Need to set bit 7 reg 0x00;
Bits 5 :3 on reg 0x01 need to be ‘100’.
After getting load cell working I can test other parts of your code.
I look forward to hearing from you