PIC18 jump from bootloader to aplication

I have a little bootloader that flash a new firmware into the top memory, when it finish i make Reset() (LINE 197) and aplication runs fine , the problem is when I turn off the circuit, it start again from bootloader

I make a eeprom variable set to 1 if flash was sucessfuly, so then if eeprom == 1 I perform a reset() (LINE 79) to force to start aplication but doesn't work


made in MPLAB X 4.20, i don't accept another version

Skills: C Programming, Electrical Engineering, Electronics, Firmware, Microcontroller

See more: microchip bootloader pic18, ikariam scripts doesnt work russian version, night version work, bootloader pic18, pic18 secure bootloader, devtrainerv211beta halo work trial version, work aplication sheet, pic18 bootloader c18, will editscript version work usb foot pedal, pic18 bootloader ethernet, dev trainer work halo trial version, perform handicraft work, can dev trainer work halo trial version, flash portal version games work, turn pictures fine hand drawn work free, bootloader pic18 tcp, aplication urgent work

About the Employer:
( 20 reviews ) Alicante, Spain

Project ID: #19260715

4 freelancers are bidding on average €34 for this job


Hi, I found that in your code at line 198 you are calling GotoAppUser(); after calling Reset(); but this is not done at line 79. Regards, Hafeez

€50 EUR in 1 day
(13 Reviews)

Hello, I am an electromechanical and electronic technician, and I only have the thesis to be an electronic engineer. I work in an electrical testing laboratory, under international standards, im work here for more t More

€30 EUR in 10 days
(2 Reviews)

I have 17 years experience with electronics and 8 years of experience in embedded electronics. I have worked with 8051, PIC, AVR, PIC24, dsPIC, PIC32, STM32, Tiva, Stellaris, LPC, MSP430, FT90x, Arduino, ChipKit, Ra More

€22 EUR in 1 day
(0 Reviews)

My projects are on [login to view URL] [login to view URL] [login to view URL]

€34 EUR in 3 days
(0 Reviews)