Gas controller automation, system will have a pressure regulator with 2-6 pressure sensors. A solenoid and a dispensing hose. System will require rfid and to recognize tags. The system will also have a verification of pressure within the hose and will fill as long as the verification of volume equals or exceeds a pre entered pressure to verify from. The system will have stop points for pressure and when pressure drops to a certain point within the system it will pressurize to the stop point. The fill hose arrangement will turn off or not activate if it doesnt identify the programmed pressure at the a connection has been made. There will be multiple entries to provide a notification in the system should various events that occur that are not suposed to happen. A message may show as what caused the failure. The messages that me shown on the screen are a filling status with graphic. Also a graphic in the HMI to show remaining gas in the gas cylinder. There may be a chart showing the fill status as its filling. On The HMI there may be 6-9 buttons to fill a particular container. This may include a graphic of the canister. Features include a password to authorize use and System would function to fill automatically by RFID and verifying pressure in fill hose. If pressure is in range it will fill the canister. otherwise a message would indicate a particular problem. In addition while the system if filling if the fill is approved and fills and notices that the fill pattern doesnt match a normal fill in time the system will shut off . There will be a main screen with a cylinder graphic, a graphic of a container. There also may be a bar code scanner within the system.
This programming is to be done on a Unitronics PLC HMI
20 freelancers are bidding on average $601 for this job
I am expert in Automation and worked on Unitronics PLC. Relevant Skills and Experience I can design, develope and commission the System within Time limit.