We have a small prototype circuit (~30 components) based on the ATtiny85 designed in KiCAD and prototyped using a Digispark. Major functionality is incoming power conversion (75v -> 5v), incoming voltage measurement, and current dump into a resistor network controlled by the ATtiny. Project scope is development of a BOM of SMD components based on the schematic and layout of a two-layer PCB. Scope could also include assembly and testing of the first few units as well if availability / skills permit. Ability to review the circuit design for errors or improvements is a plus. Experience with power conversion design using the TI LM5008 buck converter or similar would be appreciated
I will provide you more detiails
but the applicant should read the job description and don't waste my time and write a technical proposal based on it and give me an estimate for the time and budget
38 freelancers are bidding on average $554 for this job
hi... we can design your project in Altium Designer.. we ll provide to you schematics, PCB, BOM and gerber files and what you need we are interesting your project, pls give me more details.. thanks..
I am a Hardware engineer at Bosch with a lot of layout experience. I will design the PCB and the panel for you and give you all the output files for production (incl Bom, Gerbers, Stencil)
It's Good that you have used a switching regulator for voltage conversion. I have pcb design experience in Altium17 and Kicad. I can easily fulfill your requirements along with improvising it. Let me know.
My experience shows my skills . Relevant Skills and Experience Hardware Design, pcb design, part selection and purchase, bom, vendor management , hardware testing , debug and cerrification