I am looking for an electronics Engineer that has experience designing LiPo battery charging circuity.
Please do not send me cookie cutter responses. I will simply reject them.
You need to provide me a proposal that can demonstrate you know what you are doing to be qualified for further discussion about this project.
The key requirements are:
1. Being able to charge up to 16 x LiPo batteries simultaneously (4S and higher @10A) using a balance charge method.
2. The system would stop charging the batteries once fully charged.
3. The system must have a communication port that would allow external systems to be able to perform and obtain the following information about the batteries through the charging system:
a) Current Voltage of the battery and the voltage of each individual cells.
b) Being able to instruct the system via software commands what battery to charge.
c) If the battery voltage has dropped to point where it can not be safely charged again, provide the status of the such battery via software to external solutions.
d) While the battery is charged, provide each battery charge status via software.
e) being able to recycle the battery charge by discharge and charge methods.
f) Battery storage method.
I open to various microprocessors based solution that will require to provide the software communication platform.
Please provide a high level proposal.
24 freelancers are bidding on average $2416 for this job
We are experts in handling LiPo batteries, we can perfectly design a charger circuit with balancing option to balance all cells, as well as overcharge protection. Hire the BEST, forget the rest.