i have created a schematic and all parts in Altium. Next step is to place all parts and route the connections.
Some connections are analog and some connections are important because high power (60V, up to 100A).
Requirement is to place all parts on one side and the pcb must be as small as possible.
Some side requirements are descripted in the schematic (e.g. "place near T1")
The PCB is a 2-layer-PCB.
You should have experience with Altium hierarchical schematics, EMV, different signal types.
Please do not use the Autorouter, because the most signals are important because line length und power.
Ask me if you have questions.
17 freelancers are bidding on average €155 for this job
Hi I am most experienced PCB designer I have read the details I have over 8 years of experience in Altium Designer, Please get in touch to discuss it further Regards