I'm looking for someone to design a simple PCB board (both schematic and board design)
The board will contain:
1. BLE112 - a bluetooth module (no need for RF knowledge, the antenna is onboard the module)
2. ADXL345 - Analog Devices MEMS accelerometer
3. CR2032 Battery holder
4. Debug header
5. Passive components
The board should be quite a compact, on a rounded PCB, less than 3cm in diameter (smaller=better, as usual)
This is quite a simple project, not too many parts or RF/analog considerations.
I prefer receiving the files in Eagle format (both schematic and board) but am flexible.
I already have library parts for both the BLE112 and ADXL345, so no need to create them.
Plus, I'm an electronics engineer myself, so we'll be able to understand each other :-)
25 freelancers are bidding on average $154 for this job
Hello, I have designed PCB using Eagle for over 3 years, I have designed Protocol converter circuits (RS232 to 1Wire , SPI, USB ) I have refereed the datasheet you mentioned. I am ready to work on it..
Hello i am an electronic enginear. I have spent many hours on designing PCBs. I will work on it for many hours to finish the project as fast is possible.