Need PCB layout and assistance in communicating design to PCB manufacturer for complete board.
Board has the following connections:
Qty 1 - DB15 Connector
Qty 1 - Spring cage terminals for 24VDC and GND In
Qty 1 - DB9 Male Connector
Qty 1 - 5A Fuse (Removable)
Qty 1 - Female 5 pin socket for daisy-chain to next board (ribbon cable)
Qty 1 - Male 5 pin for daisy-chain in from previous board
Qty 10 - Onboard Jumpers
Qty 7 of below (All the same)
Qty 1 - TTL to 24VDC optoisolator
Qty 1 - Normally Open Relay Contact
Qty 1 - On board Potentimeter
Qty 1 - 24VDC to TTL optoisolator
Qty 1 - 2 pin connectors for plug in PCB pneumatic solenoid valves
Qty 1 - Sets of Jumpers to Switch TTL signal to above options
Need schematic, also Qty 7 - LED status Lights
Provider will need to source some components.
- Files required for manufacturing
- Bill of Materials
All connections are very simple. Map input pins to output pins with jumpers, etc.
I've attached a file that shows the connections.
This is a very simple circuit.
What I provide is just a concept sketch. The winning bidder would need to design the circuit and give me a list of components.
26 freelancers are bidding on average $136 for this job
I am an Layout PCB Engineer located in Mexico with a very good experience in PCB design, shematics, Bill materials, gerber files. My refereces is products of consum and equipament audio,medical,supply power
Need more details/part numbers of the components you are going to [url removed, login to view] also provide you the original protius file for your later improvements.
Hi We are professional PCB Design Service provider. We can give this design in PADS tool and make the schematic and fullfill the other requirements. Regards Puspraj
I CAN DO THIS JOB PLEASE CHECK MY PROFILE.I HAVE DESIGNED AND ASSEMBLED MANY DECORATIVE LED USING E PROM, MICRO CONTROLLERS FOR MANY OUTPUT PATTERN FOR A PHOTO FRAME AND GIFTS.
Schematic and layout will be done using ORCAD/[url removed, login to view] the precaution for Signal integrity,routing,trak width and copper cooling area will be taken [url removed, login to view]
We are experts in electronics circuit design and PCB [url removed, login to view] have seven years of experience in this work. we can provide you the quality solution. Please see ur PM also.