We are a small 10 person production facility producing ejector pins for commercial use in chip production. We would like to semi automate the angle grinding process of these pins. Angle and end size of pin heads are essential and we deal with micron sizes. We would like to maintain our manual grinding/honing machines and implement sensors and actuators as well as servos connected to a basic pc to automate the grinding process. At the moment the end size or tip size of the pin head is measured/estimated by eye. And could range from 0.008mm to 0.3mm with an accuracy of 0.005mm to 0.1mm. Beginning pin size is 0.7mm. our angles range from 10° to 15° with accuracy or 0.5°. Our basic machines resemble a more complex diamond cutter.
We would like to adopt a image measuring system that can alert a relay managing software to have relay output.
We are looking for anything from equipment advise to on location modifying and building equipment onto an existing machine for automation. If it is advice. We would like to know the company that can achieve this for us or software needed so we can install it ourselves.
12 freelancers are bidding on average $13710 for this job
Hello I m automation and control engineer i have finished many projects. i know siemens plcs,scada,hmi, Allen bradley plcs,hmi, Omron Plcs,ABB plcs,Mitsubishi plcs Dcs,Pcs7. and also Robotic programming;ABB,Fanuc
I am an electronics and electrical engineer with over 6 years of experience. I am very sure of doing this because I have all the skills needed for it. Message me now and let us get started