We are creating a very simple die-cut "pocket" to hold an invitation set for a client. However, we need someone to design the die lines so that we can pass on the artwork to the die-maker. A ribbon will fit through small slits in the "pocket" to hold the pocket together. Specifics are as follows:
1. Need Vector Illustration
2. Measurements are:
a. Flat: 5.75 x 13.25
b. Folded up (to create the pocket): 5.75 x 9.25
c. Ribbon Slits on the side of the pocket: .5 inch in length; .12 inch width; located .5 inch, from top of pocket and .25 inch from the side of the pocket
3. Fold/Score line (just one at 9.25" mark) must be indicated by a dashed line
Any additional information is available upon request.