I need engineering support for an automotive ecu (gasoline engine management). This system, used the Infineon microcontroller 80C517, the company has gone into bankruptcy and has been shut down. It used an MS DOS serial interface for engine calibration (maps and tables), I have the interface software. I am interested in a complete printed circuit board (pcb), code extraction from the 80C517 and an updated serial interface.
It is the 80C517 N18-T3 version, I have attached a picture. The board (approximately size of one hand) is still in a metal housing, with wiring to a serial port and to a 55 pin AMP automotive connector.
11 freelancers are bidding on average $4195 for this job
Hello. Veteran embedded systems designer here. I have completed a number of Product designs with complete Schematics and PCBs made for DFM. Please see PMB.
Hi, I am an experienced engineer with a Master's degree in Electrical Engineering. I have designed many automotive circuits and have skills in C/C++ programming, embedded systems, and PCB design.
Hi, I'm an expert in microprocessor Hw/Fw/PCB. Over 20 years in automations. Compiler architect and designer. Very expert in Rs232 at low level. Knowledge and experience in MSdos.